The resin is used to make a mold for silicone by inverting the 3d model, I’ve done it for a couple of pipe ideas before to see if they’d be cool (I’m bad at 3d design is what I learned)
I also know a guy who uses some EXPENSIVE resin that’s apparently safe to use in medical situations, so I assume breathing through that once it’s done with its treatment is probably fine, but I’d never do it with my cheap shit, even being in the room with it hurts with my mask on (hyperbole)
It fell out of alignment and no matter what I do it refuses to properly calibrate
Every test print for a month failed no matter what I did because it wasn’t moving properly and contacting support got me less than nowhere
If I ever get medicated again it’s on the list of shit to sit down and figure out cuz I bet a part is loose somewhere OR the firmware went insane and needs reinstall
Man I know that feeling. I have a prusa Mk2 that’s just… Funny about things and I’m so uninspired to fix it anymore but print ideas still come in from time to time that makes me want to figure it out.
Removed by mod
Wouldn’t do that with resin though if you are going to put it in your mouth.
Very toxic, even on skin.
The resin is used to make a mold for silicone by inverting the 3d model, I’ve done it for a couple of pipe ideas before to see if they’d be cool (I’m bad at 3d design is what I learned)
I also know a guy who uses some EXPENSIVE resin that’s apparently safe to use in medical situations, so I assume breathing through that once it’s done with its treatment is probably fine, but I’d never do it with my cheap shit, even being in the room with it hurts with my mask on (hyperbole)
What’s wrong with the printer?
It fell out of alignment and no matter what I do it refuses to properly calibrate
Every test print for a month failed no matter what I did because it wasn’t moving properly and contacting support got me less than nowhere
If I ever get medicated again it’s on the list of shit to sit down and figure out cuz I bet a part is loose somewhere OR the firmware went insane and needs reinstall
Man I know that feeling. I have a prusa Mk2 that’s just… Funny about things and I’m so uninspired to fix it anymore but print ideas still come in from time to time that makes me want to figure it out.