Don’t hold your breath

Windows is such a joke.

Shits.

I mean the third who don’t still support Trump and always will.

You should go to ML ;) they will care.

I wish.

Daily beast?

All capitalism. Including state capitalism.

China quietly moves the tanks out of the room and pretends you didn’t see.

Imagine being named Berkeley Lovelace, Jr.

Also, it’s just strawberry flavored fentanyl, what’s the big deal? Durrr

Oh, fusion is a heavy beast for sure. I just can’t stand FreeCAD’s interface.

I just wish someone would make an open source project with sketch based modeling and…. That’s all! I don’t need materials, rendering etc. I literally only need STL export.

But it needs to be as easy as shapr3d—which is marvelous, but $38usd/m for some stupid reason.

Low effort.

No one ever writes an article chastising candle obsession.

But but every mountain is covered in solar panels?! At least that’s what the ML tell me.

It doesn’t work. I’ve scoured my system and prefs and can’t find where it’s storing that I’ve done the demo. I’ve tried various emails. I’ll just run it in a VM I suppose!

If you need sheets, and you don’t have them… I’ll buy you sheets.

Where did they drop it? On the floor?

Yes

FreeCAD, as of today, looks and feels like it was made in 2010 or earlier. I’m sure there is a type of person who FreeCAD check all their boxes and excites them to no end, but I am, sadly, not in that group.

Adobe doesn’t own fusion. Did you mean Autodesk?

The cloud. I hate it. It also has way more than I actually need. It’s bulky. It’s importing assets is very limited in ways that I need.

I’ll take a look at MatterCAD. Thank you for the suggestion.