Skip Navigation

InitialsDiceBearhttps://github.com/dicebear/dicebearhttps://creativecommons.org/publicdomain/zero/1.0/„Initials” (https://github.com/dicebear/dicebear) by „DiceBear”, licensed under „CC0 1.0” (https://creativecommons.org/publicdomain/zero/1.0/)S

Stampela

@ Stampela @startrek.website

帖子
2
评论
48
加入于
3 yr. ago

  • Sovol SV06 stringing issue

    跳过

  • True about PETG, but the thing about a specific filament being stringy stands: I have a green PETG that, once it gets some time in the drier, is almost perfect. And an orange one, that can sit in the drier a whole day but still string.

  • Sovol SV06 stringing issue

    跳过

  • This could be two things, aside from what you considered. Did you increase the speed? Because if I remember correctly the SV06 has a bit of a wimpy cooling system, and as opposed to the SV07, no extra fan on the back. Another thing to consider is that sometimes you just have a filament that is stringy, did you try a different one, or so far it’s your only option?

  • [Purchased Bambu A1 mini] Low End FDM for Miniatures, Hobby Parts, and Messing Around?

    跳过

  • I have a Sovol SV07 Plus, that is the newer version of the SV06 Plus… or in other words, the mechanically identical, but larger, SV06. It’s easy to assemble, it’s bigger than the A1 Mini. Now, you don’t know how big your printer needs to be, until you find out that it’s too small! I found that the 22cm square offered by my old Ender 3 was enough for most things, but it wasn’t enough for everything. I also had a 12cm square with a Monoprice Select Mini Plus V2(the name was the biggest thing lol) and that was quick to become restrictive. Would I suggest the A1 Mini, that has halfway between the two? I don’t know. But at the same time it comes pre assembled (it might not be a concern for you) and easy to use. In short I would recommend the SV07 as that’s the small and less expensive version of what I have, but the SV06 should be mechanically identical so that gives me hope it’ll perform equally well. The downsides are a less than stellar control unit (the hardware inside the touchscreen), a weird as fuck cooling fan that is super loud, and instructions that trick you into believing that the packets of screws are numbered in a meaningful way. Don’t. That said it prints everything with ease, it’s really fast and that fan might be loud, but at the same time works wonders. I love it. Oh! Also. Once I ever so slightly fucked up the Z offset, making it scrape quite thoroughly the build surface: nothing got damaged, build surface included!

  • what's a good ip camera for home assistant?

    跳过

  • The wireless Reolinks are not great. Like, nothing against the camera itself, however, the WiFi antenna must be smaller than the one in my watch. The range is truly abysmal.

    Tapo ones are perfectly fine, good quality all around, but it’s important to specify that I have experience with external, solar powered Reolinks and indoor Tapo, so it’s a bit of a different category.

  • pooch/repkord made a printer lift itself

    跳过

  • All I can think is “Do you even lift, bro?” and chuckle.

  • The Steam Deck, nay Linux, is crying out for an official GeForce Now app

    跳过

  • Comments here are fun, seem a 3 way split between people thinking it’s GeForce Experience, game stream, and finally the actual cloud streaming service running your own Steam games.

  • Outdoor Temperature Sensor

    跳过