I have Zigbee stuff. Here’s what I like about that: they bridge between each other (if they’re powered rather than battery operated) and that extends the range. The range can be great to begin with! They’re not on my network, adding confusion or load on the access points, plus they can’t phone home… all local. Then there’s smart switches, and I’m going to point out that without WiFi they can’t be controlled, but Zigbee? Sure, I can easily power cycle my router and access points with Zigbee smart plugs! In fact I have an automation to do that daily. Finally, if something is WiFi you can’t know in advance if it’s cloud based or not, and regardless of that it’s a potentially unsafe device that is connected to the internet. Low power, but botnets work with numbers rather than power.

Opinion: if you go in chronological order, the age and quality will progress nicely, rather than jumping all around if you start with one then go back and do that sort of thing.

When I got my current printer I considered a Mini… thankfully it was too bulky to replace the MonoPrice Select Mini, and I ended up replacing that and the Ender 3 with a Sovol SV07 Plus. Looks like it was a lucky choice!

I don’t know how the various options here work, BUT you might also appreciate them too https://libredirect.github.io/index.html (this is where I found the other link)

Seems a good time to drop this here https://breezewiki.com/

Care to repeat that, laddie?

Niko, my cousin! Wanna go bowling?

As an extra to all that’s being said so far, a food safe material doesn’t mean it has a food safe pigment in it. To be honest, if all you’re going to put into the prints are packaged items (say the tea bags) then meh, not much of a big deal IMO.

Close the iris!

This reminds me that it’s a new month, and time for a backup. Thanks!

I’m saving that. Not sure if and how I could use it as I (at least try…) avoid fanning flames, but…

You might have some polypropylene there. Really strong material! Won’t stick to shit, temperature resistant, chemical resistant, can bend without breaking… never tried it, personally but it’s interesting stuff.

Sounds like TPU? Maybe soft one too.

Thanks, I think I get it. There’s a lot of humidity where I live too, so while not at the same scale, the problems are at least relatable. Best of luck with the project, it sounds like a cool but lengthy and complex journey that can really pay off!

Oh! The “brassic” guy! I don’t have much help to offer, but I didn’t know that term, had to look it up and found the tv show :D so thank you.

A tiny bit of potential help: you mention wanting to use desiccant in the boat. I’m obviously not an expert, but it sounds like a bad idea, as the stuff absorbs water… but maybe you mean in small amounts, so that wouldn’t make a difference.

Had access to cli, restarted HA and quickly disabled the Alexa integration: so far everything is working as intended :)

Similarly unfortunate situation for me, using the backup didn’t really help. But I DO have the Alexa integration, I guess next time I get HA between reboots I’ll disable that.

I think on my system it’s causing reboots. Not fun.

I’m thinking it looks like the print gets to a spot where it can get faster, and your hot end can’t keep up with the temperature required by that filament, causing under extrusion. If my guess is correct, it would show on a small test print (same settings) where you get looooong straight lines to allow for speed. And would disappear by slowing down. Since it looks like a relatively expensive filament I suggest you wait for more feedback before trying my test, just in case I got it wrong and my test would waste some filament for nothing.

Fortunately my thermometers don’t do that, because they are a good choice, Zigbee wise. Always on the lookout for replacements, if the need arises…