Check if your print is wobbling when it reaches that height. If it does, you may need to add support to fix that - a few organic support touch points halfway up should help
- Posts
- 0
- Comments
- 2
- Joined
- 3 yr. ago
- Posts
- 0
- Comments
- 2
- Joined
- 3 yr. ago
I am not too familiar with Cura, but I don't think they have the 'support painting' feature of prusaslicer and the likes that would allow this. In those, you can paint where you'd like your support to touch or use modifier meshes to selectively add regions that should be supported. It's the easiest way I know, though I have heard that Meshmixer also used to be able to do that.. but I've never tried.