cooljimy84

Unmounting CIFS , 1:30 timeout ! I just wannatgo to bed…

But beanz meanz Heinz…

I run snapraid and mergerfs, as the nas storage. Not much changes on my NAS and the stuff I really care about like my pictures and videos are on a small ZFS pool. Both are directly on proxmox, meaning I can just plug them in to another Linux machine and research if it all goes sideways. Its all shared from the host via SMB NFS or for jellyfin and immicher its a moint point for the container

I’ve heard rumours that of you change your agent string in your browser you can get past this, tho not tested yet.

Looks like a cpu/gpu type power connector. Even if its a standard plug does not mean its a standard pin out ! Craft computing on YouTube had what looked like a standard plug in his server but it had a 12volt and ground switched, so would have caused some real damage

I second this, when a drive shits the bed a sata controller handles it better, some times with a USB adapter you mess the whole bus up and need a reboot of the machine (from using them on windows experience)

Not sure on your location as from the picture it doesn’t look like you’re in the USA. However some places have restrictions on gathering water from your roof due to the materials used to clad the roof being poisonous. I would just double check that as I wouldn’t want to consume any fruits or vegetables that have been grown in water that wasn’t safe. I would also use a water butt or gatherer rather (totally covered from sun light) than hosing directly into a plant bed as if it’s raining. The plants will already be getting watered from the rainwater so you want to store the rainwater for use later.

Does it make the bleeps when you press buttons and move sliders ?

I’m sure there is a better way, but I seem to remember there was a watch folder integration that you could use to watch the TTS folder and then play that new file on a speaker. Not sure how you could then play it on the correct speaker, and I’m sure someone else has a much better real solution than this

So I don’t think HASS really names them, I think they have a default/preset name on themselves, like “TZ3000_2”

Before areas was a thing in HASS I would name things with an area name. ESP32-5-Bedroom. Now I just leave it what ever it defaults to, then use HASS to name them, and then put them in an area.

Should be fine, I’m writing to spinning rust, so if I was playing back a movie it could cause a few “dad the tv is buffering again” problems

With arr services try to limit network throughput and disk throughput on them, as if either are maxed out for too long (like moving big linux iso files) it can cause weird timeouts and failures

Another one to have a search for is IPFS.

It always throws me when I see at 1080 movie less than 5gb, then I scroll across and see it’s x265…