Been using the Venstar colourtouch T7900 for a while now and was very happy with it. But ever since configuring HomeAssistant with my local Certs/Authority (I run it all local only and access remotely via Wireguard), it won’t communicate with HA anymore. I updated the firmware and rebooted it and it came back for about a week but has since become unavailable again in HomeAssistant and rebooting fails to fix it anymore.

anyone else have this issue. or am I missing something here?

side note/context: I have both the thermostat and HomeAssistant configured with static IP addresses, if that matters at all.

  • tko@tkohhh.socialEnglish
    9·
    9 months ago

    I’m not sure what caused your problem, but I can tell you that I am using the Venstar integration with https, and it works fine for me. With that in mind, have you tried removing the thermostat from home assistant entirely, and then adding it back fresh?

    • andreas@lemmy.korfmann.xyzOPEnglish
      2·
      9 months ago

      I tried that; it re-paired but then disappeared after about a day or so. Figure there is something going on with my NAT/Avahi setup, but this shouldn’t be an issue considering it worked before I added TLS. Maybe there is a setting in HA that I need to adjust.

      I’m not as familiar with the networking configuration options in HA. I’m assuming I have everything set up correctly since everything else works as intended. I’m running it as a VM in Proxmox and my background is in network development so naturally everything else on my network is installed in regular linux vms/containers behind nginx. Is there a specific config file for https or is it just the usual HA config file?